Corkjoint CJ-100 Adhesive | Solvent-Based Contact Adhesive

SOLVENT-BASED CONTACT ADHESIVE

Description

CORKJOINT CJ-100 Adhesive is a premium quality solvent-based synthetic rubber resin adhesive formulated to bond a variety of common materials. It has high viscosity, short tack time, is easy-to-apply, offers superior bonding strength and cost savings. CJ-100 Adhesive is used to install CORKJOINT®’s range of hydrophilic waterstops and expansion joint fillerboards.

Uses

CJ-100 (CJ100) is suitable for bonding rubber, cork and closed-cell polyethylene to concrete surfaces.

Application Steps

1. Surface must be clean, dry and free of dirt, grease, oil & water

2. Stir adhesive thoroughly before use

3. Apply the adhesive to both surfaces to be bonded with a dry, clean, brush or scraper to give a uniform coating

4. Allow the solvents to evaporate until adhesive film is “tacky” or “touch dry”. It will take between 10 to 20 minutes depending upon the surface porosity and the weather conditions

5. Position the coated surfaces accurately before assembling them, and upon installation, apply an even pressure to the installed material to consolidate the bond

6. Bond strength can be fully obtained after 24 hours

Storage & Shelf Life

• Highly flammable, Store in a dry and cool place below a temperature of +30°C and keep away from all sources of heat and sunlight.

• The shelf life is 12 months in an unopened condition and if stored as per recommendations.

Packaging

• 1 Liter / Can

• 3.6 Liter / Can